Compustar Valet Mode

  • updated 7 yrs ago

What is Valet Mode?

Valet mode is a setting/feature your remote starter has, that allows you to disable the ability to remote start the vehicle. It is designed to be used when you take your vehicle in for service or if you are lending the vehicle out and wish to prohibit (ie turn off) the ability to remote start the vehicle.

What does it look like when my remote starter is in Valet Mode?

Generally, when your remote starter is in valet mode, the only thing it will do when you use the key fob is lock/unlock the doors (*if* your vehicle has power door locks AND key-less entry was connected)***see note

The vehicle may or may not respond to a key fob command with a corresponding parking light flash (this can vary between remote start brands)

Bottom line, if your remote starter is not working, valet mode is the first thing to check (to see if activated).

Note: Remote starters installed at/by Lockdown Security will always have key less entry connected *if* the vehicle has power door-locks.

How To Turn Valet Mode On or Off?

Compustar Valet Mode 

In order to exit Valet Mode follow the steps listed below: 

ALL 4 Button Remotes

  • Press and release the lock button and the trunk button simultaneously (buttons I & III).
  • Holding the buttons for over .5 seconds will cause this to fail.
  • You will receive two parking light flashes to inform you that this was successful.    

1 BUTTON REMOTES: 

If you receive 3 parking light flashes followed by 10 parking light flashes upon the remote start command:

  • Simply turn the key to the ‘on’ position and press the foot brake down 10 times within 10 seconds. 

If you do not receive these flashes:

  • Attempt to reprogram the remote to the vehicle.
  • Cycle the vehicle key between the 'off' and 'on' positions in the ignition 5 times within 7 seconds.
  • Immediately press and release the lock button on the compustar remote (button I). 

2W901R-SS REMOTE:

  • Tap the function or 'F' key on the side 3 times, then press the lock button.
  • You will receive two parking light flashes to inform you that this was successful.  

2W902R-SP REMOTE:

  • Press and release the function button and the trunk button simultaneously.
  • Holding the buttons for over .5 seconds will cause this to fail.
  • You will receive two parking light flashes to inform you that this was successful.  

NOTE: You must be within range of the vehicle, the vehicle must be turned off, the doors must be closed, and you must have battery power in both the remote and vehicle. 

 

If you do not have a remote, then the following can be attempted:

 

  • Start the vehicle
  • Press and release the foot brake pedal 10 times within 10 seconds.
  • This procedure will only deactivate Valet Mode it will not activate Valet Mode. The vehicles parking lights should flash 2 times to indicate the system has exited valet mode
Reply Oldest first
  • Oldest first
  • Newest first
  • Active threads
  • Popular
Like Follow
  • 7 yrs agoLast active
  • 5734Views
  • 1 Following